Apexi Boost solenoid
Hi all!
I'm looking at fitting a chipped ecu to my '93 wrx (which runs 1.2bar), but have been told by a few people that the standard solenoid valve won't be able to keep up! - causing creep Wondering - is the apexi boost solenoid a direct/replacement fit??? as I'm guessing this would cure boost creep problem! I heard somewhere that it has a map sensor built in, is this true?? cheers Mark. |
standard ecu cannot be mapped to 1.2bar safely as the original MAP sensor tops out at 1.23bar.. creap would be because the ecu would be seeing 1.23bar and adjusting the duty down slightly not realising the boost in the mean time is creaping to 1.4bar etc..
There is nothing wrong with the standard 3port. The Apexi 3 port is a direct replacement but would make no difference in this case. No it doesn't have a built in map sensor. Simon |
cheers, didn't realise that!
so where, and how much can I get a uprated map sensor from? thanks again Mark. |
I can see thers someone off here selling a '99 map sensor (converted to plug straight in), will this be upto the job do you think?
|
the ecu needs mapping to the new map sensor.. if it is not set up to the new one it will not run correctly..
|
are all chipped (piggyback) ecu's mappable?
can someone come out to me or does it need to be done on a rolling road? what sort of cost am I looking at to get it mapped? cheers bud Mark. |
:thumb:
|
All times are GMT +1. The time now is 03:35 PM. |
© 2024 MH Sub I, LLC dba Internet Brands