Help on fitting oil temperature sender
#1
Scooby Regular
Thread Starter
iTrader: (2)
Join Date: Jan 2005
Location: Nottingham
Posts: 86
Likes: 0
Received 0 Likes
on
0 Posts
Help on fitting oil temperature sender
Having just read up on fitting a sender above piston 3, I am unsure about sealing the sender and adapter. I have a Racetech sender and an LMA 067/M adapter, but the adapter did not come with any seals. Is it simply a case of getting a suitable O-ring for the adapter->block seal, and for the sender->adapter seal the sender comes with a metal washer is this sufficient?
Also, any recommendations for a cheap single 52mm pod for a pre-98 dash, the one I've got is a bit rubbish...
Many thanks, Aaron
PS if anyone is thinking of this job check out:
http://bbs.scoobynet.co.uk/showthread.php?t=487267
http://bbs.scoobynet.co.uk/showthread.php?t=487269
http://bbs.scoobynet.co.uk/showthread.php?t=507517
Also, any recommendations for a cheap single 52mm pod for a pre-98 dash, the one I've got is a bit rubbish...
Many thanks, Aaron
PS if anyone is thinking of this job check out:
http://bbs.scoobynet.co.uk/showthread.php?t=487267
http://bbs.scoobynet.co.uk/showthread.php?t=487269
http://bbs.scoobynet.co.uk/showthread.php?t=507517
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
JonMc
Subaru Parts
22
06 February 2016 09:50 PM