Help on fitting oil temperature sender
Having just read up on fitting a sender above piston 3, I am unsure about sealing the sender and adapter. I have a Racetech sender and an LMA 067/M adapter, but the adapter did not come with any seals. Is it simply a case of getting a suitable O-ring for the adapter->block seal, and for the sender->adapter seal the sender comes with a metal washer is this sufficient?
Also, any recommendations for a cheap single 52mm pod for a pre-98 dash, the one I've got is a bit rubbish... Many thanks, Aaron PS if anyone is thinking of this job check out: http://bbs.scoobynet.co.uk/showthread.php?t=487267 http://bbs.scoobynet.co.uk/showthread.php?t=487269 http://bbs.scoobynet.co.uk/showthread.php?t=507517 |
All times are GMT +1. The time now is 02:15 PM. |
© 2024 MH Sub I, LLC dba Internet Brands