performance mods, better running
#1
Scooby Regular
Thread Starter
performance mods, better running
hi all
i have a 1999 impreza turbo, im looking at getting the suspension and brakes upgraded, then i want to increase the bhp from what i think is approx 220? to ideally around 250bhp so not looking for a massive leap but this would be good or anything that makes the car run sweater, not that it doesnt already
I think somekind of down pipe has been recommended to me, hayward and scott i guess will do these? I have a TSL Firestorm B/B which is the best ive heard on a scooby tbh so i defo will not be changing that, dont know what the mid section is
What else is tehre i can do, 3 port solinod? panel filter?
Ta!
i have a 1999 impreza turbo, im looking at getting the suspension and brakes upgraded, then i want to increase the bhp from what i think is approx 220? to ideally around 250bhp so not looking for a massive leap but this would be good or anything that makes the car run sweater, not that it doesnt already
I think somekind of down pipe has been recommended to me, hayward and scott i guess will do these? I have a TSL Firestorm B/B which is the best ive heard on a scooby tbh so i defo will not be changing that, dont know what the mid section is
What else is tehre i can do, 3 port solinod? panel filter?
Ta!
#2
Scooby Regular
From your other posts you seem paranoid about the running of an Impreza.. If you are paranoid then dont even start playing the modification game, because unless your willing to spend BIG BUCKS you'll have a un-reliable car.
#3
Former Sponsor
iTrader: (30)
Join Date: Jan 2005
Location: FB Tuning Workshop - HP27
Posts: 4,219
Likes: 0
Received 0 Likes
on
0 Posts
If you currently have a standard car, then probably the easiest and most reliable route to acheiving around 250bhp and an equivalent amount of torque would be to find a secondhand PPP ecu and intercooler hose, then just bolt on a decat centre section and rear box of your choice.
#4
Scooby Regular
Thread Starter
thanks for the info
Originally Posted by fiestaboy
If you currently have a standard car, then probably the easiest and most reliable route to acheiving around 250bhp and an equivalent amount of torque would be to find a secondhand PPP ecu and intercooler hose, then just bolt on a decat centre section and rear box of your choice.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
20
22 October 2015 06:12 AM
matt12
ScoobyNet General
64
16 September 2015 09:16 PM
matt12
Engine Management and ECU Remapping
4
14 September 2015 09:36 AM