(!) Stuck On
#1
(!) Stuck On
Hello woundering if you could help
I changed my calipers about two weeks ago and since ive had the (!) handbrake light permintly stuck on, any ideas ? When i first changed the dics and pads it went off after the brakes warmed up but now it wont ever go off
Yes the brake fluid is all fine and the discs and pads ive checked, am i over looking something ?
Oh and i forgot to say its a 1995 WRX
I changed my calipers about two weeks ago and since ive had the (!) handbrake light permintly stuck on, any ideas ? When i first changed the dics and pads it went off after the brakes warmed up but now it wont ever go off
Yes the brake fluid is all fine and the discs and pads ive checked, am i over looking something ?
Oh and i forgot to say its a 1995 WRX
Last edited by Harvez; 08 April 2006 at 04:44 PM.
#4
Former Sponsor
iTrader: (4)
Join Date: Jan 2001
Location: ECU Mapping - www.JollyGreenMonster.co.uk
Posts: 16,548
Likes: 0
Received 2 Likes
on
2 Posts
Check that the rubber in the fluid resevoir lid is not pushed downwards so that when you put the lid on it pushes the level indicator to the bottom.. therefore illuminating the (!)..
Simon
Simon
#5
As above but mine sometimes sticks for no reason. Take off the lid and tap it a few times SOFTLY to get the float moving again. Check the fliud isnt too high too. Ive found in the past that if the brake fluid is too high the sensor cant float to the top and just seems to stay in one place.
#6
Scooby Regular
Join Date: Jul 2002
Location: Under your bonnet
Posts: 9,173
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Jolly Green Monster
Check that the rubber in the fluid resevoir lid is not pushed downwards so that when you put the lid on it pushes the level indicator to the bottom.. therefore illuminating the (!)..
Simon
Simon
Thread
Thread Starter
Forum
Replies
Last Post