Link ECU HELP
#1
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: May 2001
Posts: 698
Likes: 0
Received 0 Likes
on
0 Posts
Link ECU HELP
I need to identify a resistor on the PCB of my link ecu
When driving along car just cuts out for a few seconds then cuts back in as if some one has switched it off then back on, after talking to Simon aka JGM
suggested i check all the earths and plugs in and to the ecu
So i took the ECU out removed the PCB and checked it over ,found a resistor on Pin no 2 136B is totally burnt to the point that i cant identify the value of the resistor
I am hoping this is the problem as it is the live to the PCB
Its marked R32 on the board and it for my97wrx
can any one help ,cars been off the road for 6 months only back on the road for 2 days so am a bit pi**sed off
Gary
When driving along car just cuts out for a few seconds then cuts back in as if some one has switched it off then back on, after talking to Simon aka JGM
suggested i check all the earths and plugs in and to the ecu
So i took the ECU out removed the PCB and checked it over ,found a resistor on Pin no 2 136B is totally burnt to the point that i cant identify the value of the resistor
I am hoping this is the problem as it is the live to the PCB
Its marked R32 on the board and it for my97wrx
can any one help ,cars been off the road for 6 months only back on the road for 2 days so am a bit pi**sed off
Gary
#2
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: May 2001
Posts: 698
Likes: 0
Received 0 Likes
on
0 Posts
Link ECU
Has any one got a 97/98 link ecu laying around that they could check a resistor colour code for me ,as i have a resistor in my ECU which has burnt out ,its R32 bottom right of picture between dip switchs and capacitor
http://i1.tinypic.com/sfgpwg.jpg
Thanks in advance
Gary
http://i1.tinypic.com/sfgpwg.jpg
Thanks in advance
Gary
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Flat4x4-again
General Technical
2
29 September 2015 06:32 PM