Apexi FC and check engine light
#1
Scooby Newbie
Thread Starter
Join Date: Apr 2003
Location: Pennsylvania USA
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
Apexi FC and check engine light
Last night I had a check engine light come on and it was for the BST2 sensor, which I understand is the secondary boost controller you can put on the car. I don't have any other boost controller on the car other than the one from the factory. BST2 was reading 0.05v. Why is this?
Brent
Brent
#2
Scooby Regular
iTrader: (15)
Join Date: Jul 2001
Location: Portsmouth
Posts: 8,606
Likes: 0
Received 0 Likes
on
0 Posts
is your powerFC set up to run with the boost control kit?
on the ETC mode you can run through which options are set, ie the CEL knock warning light, O2 closed/open loop running and so on, check the boost control option is "off" maybe, check with your mapper seems to be the safest way
on the ETC mode you can run through which options are set, ie the CEL knock warning light, O2 closed/open loop running and so on, check the boost control option is "off" maybe, check with your mapper seems to be the safest way
#3
Scooby Newbie
Thread Starter
Join Date: Apr 2003
Location: Pennsylvania USA
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Peanuts
is your powerFC set up to run with the boost control kit?
on the ETC mode you can run through which options are set, ie the CEL knock warning light, O2 closed/open loop running and so on, check the boost control option is "off" maybe, check with your mapper seems to be the safest way
on the ETC mode you can run through which options are set, ie the CEL knock warning light, O2 closed/open loop running and so on, check the boost control option is "off" maybe, check with your mapper seems to be the safest way
Thread
Thread Starter
Forum
Replies
Last Post
charlesr
General Technical
9
28 September 2015 09:16 AM
TylerD529
Lighting and Other Electrical
5
20 September 2015 12:10 PM