1998 ppp ecu wont run
#1
1998 ppp ecu wont run
i have bought a ppp ecu second hand for my 1998 terzo ,the plugs fit ok but it only runs for 5 seconds then cuts out can anyone help.it is a three plug set up.
#4
Scooby Regular
Join Date: Sep 2002
Location: Nottingham
Posts: 401
Likes: 0
Received 0 Likes
on
0 Posts
I had a recent experience where I bought a "spare" MY98 ECU and wanted to check it was okay so I removed my old one and plugged the new one in, fully expecting it to not work due to the immobiliser. However the ECU ran fine, so I swapped the old one back it. Then I tried to start the car and it did exactly as you decribed - and this is with the original ECU!!!! I was in a bit of a hurry, so I plugged the "spare" ECU back in and it started fine.
Can anyone explain this to me?
This is not really thread drift, because I'm wondering if it really is the mis-match of keys to immobilser that is causing this, as surely it could not happen with the original ECU?
Andy
Can anyone explain this to me?
This is not really thread drift, because I'm wondering if it really is the mis-match of keys to immobilser that is causing this, as surely it could not happen with the original ECU?
Andy
#5
yer i did the same and had to go to subaru and get the ecu set to my keys
takes 5 min
call about as one place was going to charge me a 100 notes for this
but in the end it cost me 20
takes 5 min
call about as one place was going to charge me a 100 notes for this
but in the end it cost me 20
Thread
Thread Starter
Forum
Replies
Last Post
MightyArsenal
Wheels, Tyres & Brakes
6
25 September 2015 08:31 PM