Help with check engine light and Apexi ECU?
#1
Scooby Regular
Thread Starter
iTrader: (3)
Join Date: Mar 2004
Location: N.Ireland
Posts: 4,088
Likes: 0
Received 0 Likes
on
0 Posts
Help with check engine light and Apexi ECU?
I have a 1995 WRX and have had an apexi ecu installed for the last couple of months, last night drove home and car started juddering then the check engine light came on and car stalled, have tried looking around engine bay for wires off or hoses to no avail. Car starts and stalls straight after and check engine light comes on, any ideas?
Fuel pump prims ok and then goes off
Fuel pump prims ok and then goes off
Last edited by scoobboy; 23 September 2005 at 11:56 AM.
#3
Scooby Regular
Thread Starter
iTrader: (3)
Join Date: Mar 2004
Location: N.Ireland
Posts: 4,088
Likes: 0
Received 0 Likes
on
0 Posts
Will have a look matey
Originally Posted by Tone Loc
Do you have a commander... if so what are the volatges like for all the sensors. Do they look normal? Are all the switches working too (got to etc<sensor/Sw).
Tony.
Tony.
#6
Scooby Regular
iTrader: (1)
Sounds like what it does if the map sensor is discounted while using OEM control. But you say the map sensor signal is fine....????
With ignition on, not running it should be about 2.6V for MAP, MAF 400mV etc. Could you give us all the voltages shown on the etc>sensors screen.
Tony.
With ignition on, not running it should be about 2.6V for MAP, MAF 400mV etc. Could you give us all the voltages shown on the etc>sensors screen.
Tony.
Thread
Thread Starter
Forum
Replies
Last Post
charlesr
General Technical
9
28 September 2015 09:16 AM
TylerD529
Lighting and Other Electrical
5
20 September 2015 12:10 PM