Morning guys!!!

Was wondering if there is a 'how to' guide for extending the LED's on the knocklink. Im thinking about moving the LED's to the A pillar.

Any guides, pictures or help would be greatly appreciated!

Thanks in advance!

Stu

 

TTT

 

ive seen one somewhere stu.

i will have a search

 

This is only general info, but just wire both leads using twin core cable (or two single cores) to where you want them. It doesn't have to be thick at all (there's only about 20mA at most going through it).


LEDs have a right-way and a wrong-way round. If you get it wrong, they won't just light up; you won't damage them.

Before you take them off, look through them and you'll see two bits of metal stuff inside, one big and one small. Make sure you note down which bit gets wired to which part of the PCB and you'll be fine.