SECS Data Monitor
One of the features of this is below...
- Knock correct - degrees (ignition timing)
Does this do the same thing as a knock link would? I say this as I'm in need of a knock link but also some other data stuff.....this might do it all....
http://www.scoobyworld.co.uk/catalog...f9a376c78af2ff
Anyone able to confirm?
- Knock correct - degrees (ignition timing)
Does this do the same thing as a knock link would? I say this as I'm in need of a knock link but also some other data stuff.....this might do it all....
http://www.scoobyworld.co.uk/catalog...f9a376c78af2ff
Anyone able to confirm?
all it reads is the amount of knock correction your ecu is calculating... It is not showing knock.. you'l still need a knock link because your ecu can only do so much before it actually knocks etc.. also KC is only available on the later cars I believe (MY01 onwards)
Former Sponsor
iTrader: (234)
Joined: Jan 2003
Posts: 14,406
Likes: 0
From: Over 500ft/lbs of torque @ just 1.1bar
Depends on your state of tune, but Knocklink, boost gauge and Lambdalink does me. Only other things that may be of benefit: Oil temp gauge and charge temp gauge.
Bob
Bob
Thread
Thread Starter
Forum
Replies
Last Post




