were do i plumb into for a boost gauge?
#5
Scooby Senior
iTrader: (1)
Join Date: Nov 2000
Location: Wildberg, Germany/Reading, UK
Posts: 9,706
Likes: 0
Received 73 Likes
on
54 Posts
You don't need to T into any pipes. on the manifold where the existing thin gray vacuum pipe is located there is another port that has a rubber bung on it, just pull off the bung and plug into that, keep the rubber bung for safe keeping in case you need to remove the boost guage pipe, you will need to replace the small bung if you do this.
Thread
Thread Starter
Forum
Replies
Last Post