Knock Link
#5
I will try!! Thanks
But the Knock box have a little screw (I think is to tune up) Is this right??
I have to do it whit the spanner in the block or in the manifold do the job??
Regards
But the Knock box have a little screw (I think is to tune up) Is this right??
I have to do it whit the spanner in the block or in the manifold do the job??
Regards
Last edited by ScoobyWhite; 29 May 2005 at 09:21 PM.
#6
Scooby Regular
iTrader: (9)
Yes m8 has small sensitivity adjusment screw,turn it to max and tap the head of the bolt to check all the leds light up...
If you have any not lighting up then there have been problems with dry joints on the circuit board which is easily fixed with a small soldering iron..
If you have any not lighting up then there have been problems with dry joints on the circuit board which is easily fixed with a small soldering iron..
Originally Posted by ScoobyWhite
I will try!! Thanks
But the Knock box have a little screw (I think is to tune up) Is this right??
I have to do it whit the spanner in the block or in the top part (air inlet to the engine) do the job??
Regards
But the Knock box have a little screw (I think is to tune up) Is this right??
I have to do it whit the spanner in the block or in the top part (air inlet to the engine) do the job??
Regards
#7
Thanks for your help!
So you are telling me that the sensivity of the Knock Link adjust screw must be in the max??? Because I do not have it in this position!!
Regards
So you are telling me that the sensivity of the Knock Link adjust screw must be in the max??? Because I do not have it in this position!!
Regards
Trending Topics
#8
Scooby Regular
iTrader: (9)
In my madness if its on max any knock at all ON with the leds off with the go pedal
Originally Posted by ScoobyWhite
Thanks for your help!
So you are telling me that the sensivity of the Knock Link adjust screw must be in the max??? Because I do not have it in this position!!
Regards
So you are telling me that the sensivity of the Knock Link adjust screw must be in the max??? Because I do not have it in this position!!
Regards
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM