GEMS cannot get anti lag to function
#1
Scooby Regular
Thread Starter
Join Date: Sep 2001
Location: Tengiz the desert Kazachstan
Posts: 1,153
Likes: 0
Received 0 Likes
on
0 Posts
GEMS cannot get anti lag to function
Anyone,
a good guide to fitting esp wiring schematic is required so we can fault find
Bought a second hand plug and play GEMS for 99my.
this was originally fitted to a UK 99 and is now in my WRX STi V type R.
First place to fit it - could not finish the job, but did install it (long story)- they managed to get the engine retard advance switch to work (95 fuel map) and fitted the Anti lag switch but said they hadnt mapped it yet - and they never did.
also when i picked up the car ---- the water spray was pumping constantly with the ignition key on 2nd position?????
Second Place - have mapped the car wondefully !! but still can not get the anti lag to function. has anyone got the correct wiring diagrams for all connections??
as I understood
ALS is just a switch INPUT (i.e. it activates a MAP in the GEMS with no other connections)
ALS OUTPUT was via the ECU into the factory loom with no other connections
any help most appreciated
http://bbs.22b.com/cgi-bin/ultimateb...c;f=7;t=000701
a good guide to fitting esp wiring schematic is required so we can fault find
Bought a second hand plug and play GEMS for 99my.
this was originally fitted to a UK 99 and is now in my WRX STi V type R.
First place to fit it - could not finish the job, but did install it (long story)- they managed to get the engine retard advance switch to work (95 fuel map) and fitted the Anti lag switch but said they hadnt mapped it yet - and they never did.
also when i picked up the car ---- the water spray was pumping constantly with the ignition key on 2nd position?????
Second Place - have mapped the car wondefully !! but still can not get the anti lag to function. has anyone got the correct wiring diagrams for all connections??
as I understood
ALS is just a switch INPUT (i.e. it activates a MAP in the GEMS with no other connections)
ALS OUTPUT was via the ECU into the factory loom with no other connections
any help most appreciated
http://bbs.22b.com/cgi-bin/ultimateb...c;f=7;t=000701
Last edited by gravelexpress; 16 May 2005 at 06:07 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM