Error code 5 - how to cure?
14 May 2005, 12:09 AM
#1
Scooby Regular
Thread Starter
Join Date: Jun 2004
Location: Isle of Man
Posts: 280
Likes: 0
Received 0 Likes
on
0 Posts
Error code 5 - how to cure?
Just fitted a new ecu to the car and it's showing error 45 which is apparently boost solenoid problem or pressure sensor problem.
I'm sure the solenoid is fine as I cleaned it the other day and it switches in & out ok on test mode.
Sure the MAP sensor would be ok too because with my old ECU there was no problem and the car boosted up fine, but I've had this error code show up on 3 different ECUs that I've tried in the last week and the car is currently only boosting to about half a bar!
Any ideas? Cheers dudes!
I'm sure the solenoid is fine as I cleaned it the other day and it switches in & out ok on test mode.
Sure the MAP sensor would be ok too because with my old ECU there was no problem and the car boosted up fine, but I've had this error code show up on 3 different ECUs that I've tried in the last week and the car is currently only boosting to about half a bar!
Any ideas? Cheers dudes!
14 May 2005, 08:57 AM
#3
Scooby Regular
Thread Starter
Join Date: Jun 2004
Location: Isle of Man
Posts: 280
Likes: 0
Received 0 Likes
on
0 Posts
What the ECU or the MAP sensor/solenoid?
Can double check the connections & clean with carb cleaner I suppose. Won't hurt to try....
Just to clarify it's error code 45 not 5 like I typo'd in the title!!!!
Can double check the connections & clean with carb cleaner I suppose. Won't hurt to try....
Just to clarify it's error code 45 not 5 like I typo'd in the title!!!!
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM