WRX clutch change
#1
WRX clutch change
Could do with some help on a problem i've encountered whilst doing a clutch on a 95 wrx. The problem being that i've undone the 4 bellhousing bolts and everything else connected to the gearbox so the box should slide off. But it won't, and am wondering if there is anything else holding the box to the engine besides these 4 bolts.
#2
Scooby Regular
iTrader: (3)
Join Date: Aug 2004
Location: Cambs
Posts: 701
Likes: 0
Received 0 Likes
on
0 Posts
Yeap you need to disengage the pin that goes through the clutch fork. You can do a search on here for more info but basicly its something like this:
There is is hex key cover on the side of the bell housing, undo this then screw a 10m bolt in to the pin underneath, this will allow you to pull the pin out.
Cheers
Dan
There is is hex key cover on the side of the bell housing, undo this then screw a 10m bolt in to the pin underneath, this will allow you to pull the pin out.
Cheers
Dan
Originally Posted by mattg
Could do with some help on a problem i've encountered whilst doing a clutch on a 95 wrx. The problem being that i've undone the 4 bellhousing bolts and everything else connected to the gearbox so the box should slide off. But it won't, and am wondering if there is anything else holding the box to the engine besides these 4 bolts.
Thread
Thread Starter
Forum
Replies
Last Post
matt12
ScoobyNet General
59
08 November 2015 09:15 PM