i/c fittting and scoop splitter
#1
i/c fittting and scoop splitter
i have a 97 uk and im going to fit a wrx01 tmic, i will also be buying a splitter for the scoop from a mate the question is will the splitter still fit properly and will it have any affect as the i/c is different so it will sit differently
#2
Scooby Regular
I've done exactly this
New age WRX IC onto a MY97.
To get the most out of the IC you will need to trim the scoop undertray (the bit with the rubber seal on). You need to remove about 1" all the way round. This means the splitter may not have anything to mount too!!
Check before you buy!!
New age WRX IC onto a MY97.
To get the most out of the IC you will need to trim the scoop undertray (the bit with the rubber seal on). You need to remove about 1" all the way round. This means the splitter may not have anything to mount too!!
Check before you buy!!
#3
cheers mate is it weak enough for a stanley to cut it or did you use a file.
did you bend the original brackets or did you buy new ones
have you noticed much difference, is yours a phase 1 or 2 engine
did you bend the original brackets or did you buy new ones
have you noticed much difference, is yours a phase 1 or 2 engine
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
shorty87
Full Cars Breaking For Spares
19
22 December 2015 11:59 AM