hi
on a classic wrx exhaust cat it has a sensor bolted to the pipe just below the cat
do you need this???
im in the middle of fitting a cat replacment pipe and the boss has been welded up by the previous owner?

does the car require this sensor in order to run properly??

cheers for any help you can give

 

don't worry about it.............its only a JDM policing thing, just fit the new set-up and forget it..............

alyn

 

It's a boss for the oxygen sensor, on some downpipes (STI5) it's above the cat right behind the turbo and on others it's lower down near the bend. On my Magnex downpipe there are two bosses, I have my oxygen probe in the top one and the bottom one is blanked off.

When I was last chatting to Mr Rawle, he reckons it;ll run fine without an oxygen sensor. Apparently the ECU only uses it for fine tuning the mixture when cruising. That's my enderstanding of what he said anyway...

Isn't there a CEL fix for if you're running without a sensor? Something like a resistor and capacitor across two terminals of the ECU?

 

thanks
had done a search and the consensus seem to say its a car overheat sensor and not important
put it all back together now

 

oh by the way
car is a sti-ra version 2

 

ahh yes the "CAT on fire" sensor, yep bin it, makes no difference..


Andy