To all that have gone from slanty to straight IC
#1
Scooby Regular
Thread Starter
Join Date: Aug 2001
Location: Stockport Cheshire Xbox Gamertag: Scooby WRX SMACS Member
Posts: 2,467
Likes: 0
Received 0 Likes
on
0 Posts
To all that have gone from slanty to straight IC
Did you use the OEM later brackets or did you fabricate your own ???, piccys would be very helpful
Si
Si
#2
Scooby Regular
Join Date: Jan 2005
Location: Bath, UK
Posts: 60
Likes: 0
Received 0 Likes
on
0 Posts
I'm going to fabricate my own mate
Basically I'm taking the IC to an aluminum fabricators (Spec R)...they said they would offer it up to the engine and make all the changes from there.
I;m unsure about the fitment of later MY brackets as the whole inlet manifold is different and therefore may have different locating holes for brackets.
Basically I'm taking the IC to an aluminum fabricators (Spec R)...they said they would offer it up to the engine and make all the changes from there.
I;m unsure about the fitment of later MY brackets as the whole inlet manifold is different and therefore may have different locating holes for brackets.
#4
Scooby Regular
Thread Starter
Join Date: Aug 2001
Location: Stockport Cheshire Xbox Gamertag: Scooby WRX SMACS Member
Posts: 2,467
Likes: 0
Received 0 Likes
on
0 Posts
Bollox oh well just got a pair of OEM brackets but I'm sure I will be albe to adjust them to fit
#5
Scooby Regular
Join Date: May 2002
Location: Taunton
Posts: 1,178
Likes: 0
Received 0 Likes
on
0 Posts
Fabriacted my own, just the one, on the right as you look at the engine. The left side of the intercooler sits on one of the original mounts and I mounted a rubber bush here and that holds it up and tight.
Fabricated mount:
http://img.photobucket.com/albums/v1.../icinplace.jpg
The original mount that holds up the left side (with rubber bush) is circled in red in this picture (ignore other red circle on right):
http://img.photobucket.com/albums/v1...vacuumhose.jpg
Fabricated mount:
http://img.photobucket.com/albums/v1.../icinplace.jpg
The original mount that holds up the left side (with rubber bush) is circled in red in this picture (ignore other red circle on right):
http://img.photobucket.com/albums/v1...vacuumhose.jpg
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM