2.5" or 3" exhaust
#1
2.5" or 3" exhaust
I have a my 94 WRX running around 300 bhp with a bit more to come thanks to a few mods (fuel pump 440's fmic and a well mapped scooby ecu) cheers pavlo. Is it worth my while moving on to a 3" full system or am i fime for a while on the system i have at the moment.Which is a Magnex twin dump downpipe to a 2.5" non resonated centre section with a 6*4" magnex back box. Thanks in advance.
Barry C
Barry C
#5
Scooby Regular
Join Date: Nov 2000
Location: 32 cylinders and many cats
Posts: 18,658
Likes: 0
Received 1 Like
on
1 Post
I went from Magnex 2.5 to Revolution 3" and found just the opposite, but the Magnex backboxes are fairly quiet. I've always found the standard Scoobysport backboxes obnoxiously loud, except for the occasional schoolboy satisfactions of ripping through the gears, but usually they are just embarrassing.
If you have to go 3" for power reasons and don't like noise, the best bet is probably a 3" Revolution with lots of extra silencers in the centre section (custom job, ends up more expensive).
If you have to go 3" for power reasons and don't like noise, the best bet is probably a 3" Revolution with lots of extra silencers in the centre section (custom job, ends up more expensive).
#6
Thanks for the info gent's it is very helpfull. Noise is not the reason to change to a 3" set up. I was Just wondering if it was getting a bit restrictive on 2.5" at that power.
Cheers for the info
Barry c
Cheers for the info
Barry c
Thread
Thread Starter
Forum
Replies
Last Post
fatboy_coach
General Technical
15
18 June 2016 03:48 PM