Ok on my MY94 gt i made a ecu check (for trouble codes).

But I made a mistake, when I put conectors together (black ones) I started the engine! Now everytime, I want to start engine, when ignition is on the check engine light is pulsing a trouble code. When the engine start the light is on and donīt go out. I already done an ecu reset (with disconect accu), but it doesenīt help.

Any ideas?

I have another problem with clutch or gearbox. I donīt know what is a problem. A transmission handle donīt go in gear when engine ideling. If engine is not runing it is going without problems. A clutch pedal is ok by a feeling, a clutch is new. I suspect a hidraulic system for clutch?!

 

Have you tried to reset the ECU after you made the mistake?
http://www.saxonfields.freeserve.co....htm#_ECU_Reset


Try bleading the clutch system. You may have air trapped in there.

Hope you get it sorted

 

have you disconnected the diagnostic plugs???
sounds the most feasible................they should be 'open' unless you are accessing a fault code

alyn

 

I have wired those conectors trough a switch. Now i have to look, if there is some short circuit. It is only possible think, because i made an ecu reset 2 times and have nothing change.

A bigger problem i think is with clutch. A hidraulic (from pedal to handle, which is on top of gearbox and go to the cluch) is ok. An arm, handle is moving when I pressure a clutch pedal. Hidraulic oil is ok, full.

Can be some different problem? I can gearing normal when engine is off, when it`s idleing i can`t.