ecu problem
 

Ok on my MY94 gt i made a ecu check (for trouble codes).

But I made a mistake, when I put conectors together (black ones) I started the engine! Now everytime, I want to start engine, when ignition is on the check engine light is pulsing a trouble code. When the engine start the light is on and don´t go out. I already done an ecu reset (with disconect accu), but it doesen´t help.

Any ideas?

I have another problem with clutch or gearbox. I don´t know what is a problem. A transmission handle don´t go in gear when engine ideling. If engine is not runing it is going without problems. A clutch pedal is ok by a feeling, a clutch is new. I suspect a hidraulic system for clutch?!

Have you tried to reset the ECU after you made the mistake?
http://www.saxonfields.freeserve.co....htm#_ECU_Reset


Try bleading the clutch system. You may have air trapped in there.

Hope you get it sorted :)

have you disconnected the diagnostic plugs???
sounds the most feasible................they should be 'open' unless you are accessing a fault code

alyn

I have wired those conectors trough a switch. Now i have to look, if there is some short circuit. It is only possible think, because i made an ecu reset 2 times and have nothing change.

A bigger problem i think is with clutch. A hidraulic (from pedal to handle, which is on top of gearbox and go to the cluch) is ok. An arm, handle is moving when I pressure a clutch pedal. Hidraulic oil is ok, full.

Can be some different problem? I can gearing normal when engine is off, when it`s idleing i can`t.