Mounting MAF vertically for induction system.
23 November 2004, 07:32 PM
#1
Mounting MAF vertically for induction system.
Just wondering what the thoughts were on the following.
Cutting a hole in the inner wing and mounting the filter under the arch and the MAF bolted to the inner wing and filter, vertically. I then want to run a silicon pipe between the maf and inlet pipe.
Similar to this
http://www.tweenierob.co.uk/beario/beario1.jpg
Cheers,
Wayne.
Cutting a hole in the inner wing and mounting the filter under the arch and the MAF bolted to the inner wing and filter, vertically. I then want to run a silicon pipe between the maf and inlet pipe.
Similar to this
http://www.tweenierob.co.uk/beario/beario1.jpg
Cheers,
Wayne.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
