Finally I have my AVC-r installed and connected....

I am unsure of a few setting, can someone please point me in the right directions:

Current Setup:

Using Setting A
Boost/Duty:
1.20 72

5500 onwards the the boost is set to drop to 1.1 bar

Start Duty:
1 +0
2 +1
3 +1
4 +1
5 +0

Learn Mode Disabled

When I am driving the boost generally does not go beyond 1.25bar, sometimes may hit 1.28 but does drop down to 1.1bar after 5500rpm.

Fall Back Speed Setting
Currently set to the default 3 3 3 3 3

What should I set the fall back speed to? and what does it actually do?

Sam

 

As far as I can remember, Feedback Speed controls the 'reaction time' of the solenoid

I found that adjusting this didn't make much difference, so i turned it off (X)

If you want to maintain high boost at the top of the rev range, just up the duty% a bit, wherre it currently drops off.