I have been given a dawes device that was set to 1.25bar but the original owner can't remember how to fit it so can someone please tell me where this thing goes and how to adjust it.

Also It was recommended that I slightly increase the vent hole in it is this true or not?

Cheers

Steve

 

Detailed instructions here: http://stefanostadal.homedns.org/car_mods_engine.htm

Very, very easy to do. Only takes a couple of minutes.

Bob

 

Excellent! thanks Bob

Steve

 

What about early models with a 3 port solenoid ?

Mark A

 

Cant be much different. I think where the 2 port uses a t-piece the 3 port has a seperate pipe. Not sure though....its much easier once your under the bonnet.

From memory 2 pipes connect onto dawes and the other is blanked off with a bung/screw. Would assume it is the same for 3 port.

Bob