Hi there peeps,

Got my car back after an engine rebuild, just finished running in the engine (1000 miles of fustration).

Anyway i have only put my foot down a couple of times since its runs in but it boosts to nearing 1.5bar and hits fuel cut. It was on 1 bar max before rebuild, so need it to be the same again (hoping not to pop the block).

What can this be? actuator not corrected? i dunno help

anyone around guildford area tomorrow nite to help????

need to get this sorted before fri,as im following a supra and tuned up gt4 to amsterdam for a show.

Please

 

What car is it? Sounds like the boost restrictor has gone walkies Also check the boost solenoid is all plugged in correctly.

Dont go putting your foot down in the meantime It will still det before fuel cut.

MB

 

Its a 95 wrx matey, its had a few bits done so i dont know if that would have any bearings?

Sti head gasket and cosworth forge pistons?

will check the solenoid tomorrow

 

Take it back and ask for it to be sorted.

MB

 

Yea i think it would be best, im gonna call him up tomorrow and tell him the problem, and hope that he can sort it promptley

Cheers for your help matey