Have been offered a set of 17" superleggara alloys cheap, but need to know the correct offset they are 8 * 17" with offset of 100 pcd, they were off a Celica GT4.

Can someone get back to asap on this as need to buy em yesterday, cheers.

 

Does anyone know if they will fit?

 

If they are 8 inch wide then they need to be around an ET50
7.5 inch can be anything between ET48 and ET53

 

So are they too big at pcd of 100 ,thats what the guy thinks they are, but they fit a GT4 so thought thay might have fit?

 

PCD 100 is not the off set, not sure what its stands for but its the stud pattern, ie thay may not even fit on the hub, not sure what PCD a scoob is tho

 

DOH, ok then is stud pattern of 100 PCD correct for a classic?

 

yes , Subaru pcd is 5 x 100 pcd .

just check the offset .

I think the toyota off-set is about et38 tho ? ?

 

yes i think they are

 

So they wont fit then?

As been offered a set of superleggaras for £200

 

you could offer them up, but i reckon they're about 10mm "sticking out too far ! "