Need jdm sti ver.3-4 ecu pinouts
01 September 2004, 10:26 AM
#1
Scooby Newbie
Thread Starter
Join Date: Aug 2004
Location: AZ
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
Need jdm sti ver.3-4 ecu pinouts
I need the pinouts for a jdm sti ver.3 or 4 ecu. I am almost done with my motor swap but the pinouts I have are not quite right. P.M. me if you have any pinouts for my ecu. Thanx
09 September 2004, 10:28 AM
#3
Scooby Regular
Join Date: Oct 2001
Posts: 1,833
Likes: 0
Received 0 Likes
on
0 Posts
Have a look at www.ravensblade-impreza.com > Tech docs/info > Wiring guides
http://www.ravensblade-impreza.com/m...wiring/jpg.jpg
http://www.ravensblade-impreza.com/m...wiring/jpg.jpg
http://www.ravensblade-impreza.com/m...wiring/jpg.jpg
http://www.ravensblade-impreza.com/m...wiring/jpg.jpg
Hope this helps you!
JIM
http://www.ravensblade-impreza.com/m...wiring/jpg.jpg
http://www.ravensblade-impreza.com/m...wiring/jpg.jpg
http://www.ravensblade-impreza.com/m...wiring/jpg.jpg
http://www.ravensblade-impreza.com/m...wiring/jpg.jpg
Hope this helps you!
JIM
Last edited by JIM THEO; 09 September 2004 at 10:30 AM.
18 October 2004, 11:14 PM
#6
Scooby Newbie
Join Date: Jun 2004
Posts: 8
Likes: 0
Received 0 Likes
on
0 Posts
Sorry to bring this thread back from the dead...but I'm in need of his information as well. =(
I've been working with the RavensBlade pinouts, but am still having some wiring issues. Did anyone ever end up finding a different set of pinouts for a Version 3?
J.
I've been working with the RavensBlade pinouts, but am still having some wiring issues. Did anyone ever end up finding a different set of pinouts for a Version 3?
J.
Thread
Thread Starter
Forum
Replies
Last Post
