STI7/8 Intercooler on Classic???
#3
got a vague answer to my question here, apparently it's possible, but i was hoping for some words of wisdom from anyone who'd actually done it!
will check out 22.com now!
will check out 22.com now!
#4
Ive seen it done on a rb5 he used one of the original mounting points and extened the other one. You have to use the dump valve from the new age.Depends which car you've got though i dont think it would fit on a pre face lift.
Matieboy.
Matieboy.
Trending Topics
#9
Scooby Regular
iTrader: (1)
Join Date: Mar 2002
Location: North East Subaru Forum
Posts: 3,920
Likes: 0
Received 0 Likes
on
0 Posts
i have fitted a sti 7/8 intercooler to a 99uk classic, not a hard job but there are a few things you need before starting the conversion.
90 deg 51mm silicone hose.
brackets from the v7/8 intercooler
brake fluid
sti7/8 dump valve/ blanking plate
on the left side use the bracket from the v7/8.
on the right you will have to bend the original (harder than it sounds)
you also need to cut 2cm from the bottom of the plastic bit on the clutch res.
hope this helps
90 deg 51mm silicone hose.
brackets from the v7/8 intercooler
brake fluid
sti7/8 dump valve/ blanking plate
on the left side use the bracket from the v7/8.
on the right you will have to bend the original (harder than it sounds)
you also need to cut 2cm from the bottom of the plastic bit on the clutch res.
hope this helps
Thread
Thread Starter
Forum
Replies
Last Post