I have a wrx my94 the cel light came on and stoped on so i re-set the ecu, 42,idle switch or circuit 44,wastegate duty solenoid the car seem's to be running fine, but i have noticed the air fuel gauge has started running a bit rich. Im running a dawes boost controller so dont think im useing the wastegate duty solenoid?

can i clean these sensor's or will they have to be replaced thanks for any help

 

Check the connection on the WDS, the error only usually appears if it is disconnected.
Idle switch... How tight is your throttle cable? this is normally the prob...

Rob

 

Thanks for the reply Rob

right checked the plug on the WDS seems fine, as for the cable it not been touched since i've had the car! how do i loosen the cable "sorry for been thick"

The WDS chris has the original one of my car, from when you swaped it so if worst come to worst i can go and swap it back, but not realy botherd coz as you know i've got a dawes boost controller just want the dam cel light to stay off

also where is the idle switch " been a bit thick again" lol