induction filter fitment...?
13 August 2004, 10:34 AM
#1
Scooby Regular
Thread Starter
iTrader: (15)
Join Date: Jul 2001
Location: Portsmouth
Posts: 8,606
Likes: 0
Received 0 Likes
on
0 Posts
induction filter fitment...?
I have just taken delivery of an Apexi induction kit and am going to attempt fitment this afternoon.
I assume (on my 99car) that the copne simply bolts onto the existing induction piping just after the MAF sensor (when heading away from the engine) thereby allowing me to horse all the oem box and junk in the wing.
am I mistaken?
Andy
I assume (on my 99car) that the copne simply bolts onto the existing induction piping just after the MAF sensor (when heading away from the engine) thereby allowing me to horse all the oem box and junk in the wing.
am I mistaken?
Andy
13 August 2004, 02:52 PM
#2
Scooby Regular
Join Date: Feb 2004
Posts: 1,063
Likes: 0
Received 0 Likes
on
0 Posts
hi
i got on on my99 it goes on the pipe with the maf on it its easier to disconn the maf and take it all out the bolt the apexi on becareful not to tighten the nuts too much, make sure you have the rubber bit which goes in between the maf and the induction kit
i got on on my99 it goes on the pipe with the maf on it its easier to disconn the maf and take it all out the bolt the apexi on becareful not to tighten the nuts too much, make sure you have the rubber bit which goes in between the maf and the induction kit
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM