Trolley Jack adapter for side sill
09 August 2004, 08:40 PM
#1
Scooby Senior
Thread Starter
Join Date: Sep 2003
Location: Essex
Posts: 2,600
Likes: 0
Received 0 Likes
on
0 Posts
Trolley Jack adapter for side sill
I made up this handy dandy adaptor so a trolley jack can be used on the std side sill jacking points. Much safer than that scissor jack.
The gap between the Two square sections is 11mm and the plate is 100mm square, with the smaller square section being 50mm long for locating. The jacking force is taken by the longer square section so this is in the middle of the plate.
Dipster
The gap between the Two square sections is 11mm and the plate is 100mm square, with the smaller square section being 50mm long for locating. The jacking force is taken by the longer square section so this is in the middle of the plate.
Dipster
Last edited by davedipster; 25 August 2004 at 08:18 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
Sub-Subaru
General Technical
1
28 September 2015 12:47 PM
