IS IT A MUST TO HAVE THE GEOMETRY DONE AFTER FITTING EIBACH SPRINGS?
02 June 2004, 09:20 PM
#1
IS IT A MUST TO HAVE THE GEOMETRY DONE AFTER FITTING EIBACH SPRINGS?
HAD A PRICE ON HAVING EIBACH SPRINGS FITTED TO MY BUG EYE 01 WRX.I WAS THEN TOLD THAT I WILL NEED A GEOMETRY SET 1000 MILES LATER.
ONLY TO PHONE TSL FOR A PRICE.THEY TOLD ME THAT THE SET UP HAS TO
BE DONE AFTER THE SPRINGS ARE FITTED
HAS ANYONE ELSE HAD THIS DONE?AND WAS IT AT TSL??
02 June 2004, 11:53 PM
#3
Scooby Regular
iTrader: (1)
Join Date: Dec 2001
Location: You only live ONCE But if you do it right >>>>> ONCE is enough
Posts: 7,327
Likes: 0
Received 0 Likes
on
0 Posts
I had the Prodrive springs supplied & fitted & the geometry done to Prodrive settings at Wilsons near Romford.
Good service & the wagon handles like a dream now.
Dont skimp on not getting the geometry done or you will trash your tyres.
SEE HERE
Mark.
Good service & the wagon handles like a dream now.
Dont skimp on not getting the geometry done or you will trash your tyres.
SEE HERE
Mark.
03 June 2004, 10:14 AM
#4
Don't forget - if the front struts have been removed, then unless the guy who did it marked the camber adjustment bolt and replaced it as before, the camber is very likely to be out. This is a good opportunity to apply any recommended settings to compliment the new springs.
JohnD
JohnD
Thread
Thread Starter
Forum
Replies
Last Post
ATWRX
Full Cars Breaking For Spares
88
01 February 2016 07:28 PM