boost gauge
#1
boost gauge
does anybody know where i can get boost gauge hosing from. I have just brought a second hand boost gauge. It has got a long nylon pipe on it, but i need to find the right pipe to fit it to the engine. i have a my99 so there is a blanked off pipe for it to go on. but the pipe i have got is to small.
cheers Jason
cheers Jason
#2
Boost guages usually have a small pipe , I think you may be looking at the wrong pipe on the scoob. Most guages i have seen are fitted with a "tee" connector to the small pipe from the boost control valve ( fitted to the boost / ignition panel that lives on the offside suspension turret ) and the turbo.
Steve
Steve
#3
On a UK turbo, you can take the reading from a blanked off nipple on top of the inlet manifold - I think the blanked off pipe you are on about is probably the one.
I used a 3mm internal diameter piping for this - general nylon ones are fine.
I used a 3mm internal diameter piping for this - general nylon ones are fine.
#4
Scooby Regular
iTrader: (1)
Yep, most motor factors will have what you need. I used a rubber hose, 3mm internal diameter. Nice snug fit onto the nipple on the block and the hose from the gauge, but used cable ties to secure. Don't do the hose/hose connection too tight though else you won't get a reading.
#6
Scooby Regular
iTrader: (2)
Join Date: Dec 2002
Location: All over the place, trying to stop putting the miles on!
Posts: 1,197
Likes: 0
Received 1 Like
on
1 Post
If is the autometer gauge (sounds like it is from the description), then if you go to halfrauds you will find some 't' pieces in their washer section and with a little help from a drill the small nylon pipe will fit inside the 't' piece with a bit of superglue to hold it in place.
Hey presto one pipe size convertor.
Dan.
Hey presto one pipe size convertor.
Dan.
Thread
Thread Starter
Forum
Replies
Last Post