HKS electronic Peak hold Gauge gone lala
27 November 2003, 02:34 PM
#1
Scooby Regular
Thread Starter
Join Date: Jan 2001
Posts: 2,542
Likes: 0
Received 0 Likes
on
0 Posts
Hi,
I have a 60mm HKS Electronic Peak hold boost gauge.
Recently I've noticed it's starting to overread by 0.2 bar for no apparent reason.
The boost display on my Boost controller consistently reads 0.2 bar less and also when the igniton is on but the engine is off the gauge does its normal sweep on setup and then settles at 0.2 bar +ve pressure.
The unit has a little pressure gauge that you mount under the bonnet with cables running from it into the back of the gauge.
Could this little unit be knackered?
There appears to be no way of recalibrating it.
Anyone any ideas?
Cheers
Rich
I have a 60mm HKS Electronic Peak hold boost gauge.
Recently I've noticed it's starting to overread by 0.2 bar for no apparent reason.
The boost display on my Boost controller consistently reads 0.2 bar less and also when the igniton is on but the engine is off the gauge does its normal sweep on setup and then settles at 0.2 bar +ve pressure.
The unit has a little pressure gauge that you mount under the bonnet with cables running from it into the back of the gauge.
Could this little unit be knackered?
There appears to be no way of recalibrating it.
Anyone any ideas?
Cheers
Rich
Thread
Thread Starter
Forum
Replies
Last Post
crazyspeedfreakz
Wanted
17
05 October 2015 07:19 PM