Removing engine - nearly there - urgent HELP please
27 November 2003, 08:38 AM
#1
Scooby Regular
Thread Starter
Join Date: Nov 2003
Location: www.LittleKnocks.co.uk in Harefield
Posts: 50
Likes: 0
Received 0 Likes
on
0 Posts
I'm removing the engine from my MY94 WRX.
The engine is seperated from the gearbox by about an inch but wont move any further. Any ideas ???
Thanks in advance
Tom
The engine is seperated from the gearbox by about an inch but wont move any further. Any ideas ???
Thanks in advance
Tom
27 November 2003, 08:59 AM
#2
Scooby Regular
Join Date: Jul 1999
Posts: 821
Likes: 0
Received 0 Likes
on
0 Posts
It is being held on by the clutch bearing fork.
Remove starter, undo hex-socket bolt behind it, stick an M10 (M8?) bolt into hole and screw it in, pull to release the fork......do a search, there are loads of pics etc on other sites.
Remove starter, undo hex-socket bolt behind it, stick an M10 (M8?) bolt into hole and screw it in, pull to release the fork......do a search, there are loads of pics etc on other sites.
Thread
Thread Starter
Forum
Replies
Last Post