Reading the ECU
#2
Chris,
If you've got a fault, the engine check light on the dash will be on.
To find out what the fault is:
1. switch off ignition
2. connect the black or brown plugs under the dash
3. turn on ignition
4. the check engine light will flash at you. Long flashes are 10s, short are 1s, (e.g. 44 is four long, four short). If you've got more than one fault another number will flash at you, other wise the same no. will repeat.
5. turn off ignition
6. disconnect plugs.
Steve.
If you've got a fault, the engine check light on the dash will be on.
To find out what the fault is:
1. switch off ignition
2. connect the black or brown plugs under the dash
3. turn on ignition
4. the check engine light will flash at you. Long flashes are 10s, short are 1s, (e.g. 44 is four long, four short). If you've got more than one fault another number will flash at you, other wise the same no. will repeat.
5. turn off ignition
6. disconnect plugs.
Steve.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM