Fitting a Boost Controller? (manual)
10 April 2003, 07:10 PM
#1
Scooby Newbie
Thread Starter
Join Date: Sep 2003
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
Just want to check that I understand this right.
1-Boost controller is to be fitted between the pressure source (compressor nozel) and the actuator.
2-Then the feed from the solenoid to the wastegate is blanked off instead of t-piecing into the feed in step 1?
Thus the boost controller regulates boost instead of the solenoid/ecu......
Does that sound right?
[Edited by wizardly - 10/4/2003 7:13:28 PM]
1-Boost controller is to be fitted between the pressure source (compressor nozel) and the actuator.
2-Then the feed from the solenoid to the wastegate is blanked off instead of t-piecing into the feed in step 1?
Thus the boost controller regulates boost instead of the solenoid/ecu......
Does that sound right?
[Edited by wizardly - 10/4/2003 7:13:28 PM]
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
aaron_ions
General Technical
1
17 September 2015 10:42 AM