Tips on adjusting ScoobySport Cibie's
#2
Although I found fitting the Cibie kit from ScoobySport dead easy, I'm finding that adjusting the beam direction a little more difficult.
At present, the light seems too low and could do with being raised.
Now I understand that to achieve this, I should 'pack out' the bottom 2 fixings with washers, but has anyone got any tips on do this as every time I try, the ba$£@rds fall out before I put the bolt back.
At present, the light seems too low and could do with being raised.
Now I understand that to achieve this, I should 'pack out' the bottom 2 fixings with washers, but has anyone got any tips on do this as every time I try, the ba$£@rds fall out before I put the bolt back.
#3
Scooby Regular
iTrader: (1)
Dave
After fitting my Cibies i tried adjusting them with 1mm washers.A few hours later ended up where i started - no washers !
Seems to give the best compromise.On v.fast roads though, could do with longer beams.Think a good combination might be drive lens nearside, spot off side ?
After fitting my Cibies i tried adjusting them with 1mm washers.A few hours later ended up where i started - no washers !
Seems to give the best compromise.On v.fast roads though, could do with longer beams.Think a good combination might be drive lens nearside, spot off side ?
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM