Does that mean that it´s not needed ,before i put on thermocouples

Just want to be sure.

I woun´t buy thermocouples,before there is software that can log it!!!

I´m planning to run this in my car all the time with the display..
i´m not using the NB OE sensor for anything other than logging,so i will just mount the WB in that bung.

Thanks,
Skassa

[Edited by Denmark - 9/2/2003 3:43:38 PM]

 

Made a new message

Skassa

[Edited by Denmark - 9/3/2003 11:01:43 PM]

 

Hi All,
On the logger side of the WB controller there is a ground ,is this ground for thermocouple only or is it just car ground...

Any one know????

Thanks,
Skassa

 

Skassa,

Hi it's Mr "I've not tried it myself yet but here's what I think" again...

Looking at the WBO2 Schematics

When you say the logger side do you mean the ground on the 8 way 'logger inputs' conector? This is not the vehicle ground but a ground for the high gain amp though which all analogue inputs are fed (ie T1-T3 & V1-V3) but not the RPM signal which does seem to use the vehicle ground.

Andrew...

 

I meant to add that I'm still waiting for my 057 connector and then I should be able to be more positive in my replies.

Are you planning in using the simulated N/B connected to your Link?

Andrew...

 

No it's only needed if you are connecting TCs or the analogue inputs (V1-V3).

Andrew...