I finished installing my Defis last night. Does anyone know the max boost used by a SobbySport "Tek-2" remap? I want to see if the car is using the boost it's supposed to be using. I've seen 1.0 bar, I think.

I don't know the exact answer to be honest, but I would bet more than 1 bar ---> I regularly achieve between 1 and 1.1 bar on my MY02 with just a full decat/panel filter (no remap as yet).

Or at least that's what the 'peak' settings on my defis tells me

I have a TEK3 and often see 1.37, couple of spikes in the heat up to 1.52

My Tek 2 from Pete has given me 1.18 bar (16.5psi), tonight
on a short midnight shopping run; according to the SECS monitor.

I wasn't pushing hard, so I'd expect slightly more, if I really
tried.

Car is an old shape '99.

My bugeye my01 hits 1.27bar with the scoobysport remap.

Gordo

When I went out to "test the gauges" the peak value recorded was around 0.8 to 0.9 bar. I wasn't giving it the full beans though.

...also, what's a normal warmed-up oil temperature? I'm seeing about 90°C when warmed up. Is that normal?

Hi Fatman,
"The Normal oil temp" that you will read will depend on where you've put the sensor...if it's in the positon of the blanking plug on the block then you've got it in the same place as me...usual temp is around 94-96 I'd say when warmed up...but the peak I've registered is 108...not on track,but after fast driving as the engine had a bit of heat soak duing the cool down part of the drive....motorway driving regularly sees temps of 98-104....I think if you had the sender in the sump temps would be more like 85-95 steady state...and probably with less fluctuation due to more volume being present around the sensor giving more stable conditions...

[Edited by crusher - 8/21/2003 4:02:59 PM]

I had Tec2 which peaked @ 1.3bar

Now have Tec3 somethimes goes over 1.5 bar(only if my foot slipps though )

I installed the sensor in the cylinder-3 oil gallery plug position (below the throttle assembly). I've not done any motorway driving since installing the gauges. Perhaps that's why I've not seen temps quite as high .

1.1BAR on the nose.....
On an MY99/00

[Edited by Scott.T - 8/23/2003 9:56:03 PM]