Parallel Fuel Rails and Servo Pipe
#1
Here I go again,
I will be having a go at the parallel fuel rail mod in the week but have just thought about fitting and remembered that I have a 5th injector..(WRX RA)
What shall I do with it.
Fit it on at the end of a rail or somewhere else, or get rid as it doesn't do anything anyway.
But how do I blank it off?
NEXT PROB:
I have been having a knocking sound from my I/C when starting up and switching off the car, This is because I have a STi4 Intercooler on my MY94 WRX. It is knocking on the Brake servo pipe which runs along the bulkhead.
As this is a steal pipe can I remove it and replace with some 10mm Reinforced hose, as the 2 ends are rubber hose anyway.
Or shall I leave alone and remove a bit more from the throttle body.
Thanks again for your help, don't know what I would do without you lot.
Scott
I will be having a go at the parallel fuel rail mod in the week but have just thought about fitting and remembered that I have a 5th injector..(WRX RA)
What shall I do with it.
Fit it on at the end of a rail or somewhere else, or get rid as it doesn't do anything anyway.
But how do I blank it off?
NEXT PROB:
I have been having a knocking sound from my I/C when starting up and switching off the car, This is because I have a STi4 Intercooler on my MY94 WRX. It is knocking on the Brake servo pipe which runs along the bulkhead.
As this is a steal pipe can I remove it and replace with some 10mm Reinforced hose, as the 2 ends are rubber hose anyway.
Or shall I leave alone and remove a bit more from the throttle body.
Thanks again for your help, don't know what I would do without you lot.
Scott
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
hedgecutter
General Technical
3
25 September 2015 02:35 PM