where to put wire for AFR?
#2
It has to go on the output of the Lambda sensor. If yours is a 3 wire one the wires are black/red/white. The white one is the signal output wire. If it is a 4 wire then I don't know but someone will. The output goes into the ECU but I don't know which the wire for that is, once again someone else will know for sure. I attached mine to the white wire from the sensor.
Les
Les
#4
DONT scotchblock it..!!!!!!!! they are crap for connections like this..!!
If you dont want to run a wire through the fire wall then take the o2 signal from the ECU, i did this on my MY95 WRX you want pin 6 on connector block B43 think it will be the same for the UK ECU.
Dan
If you dont want to run a wire through the fire wall then take the o2 signal from the ECU, i did this on my MY95 WRX you want pin 6 on connector block B43 think it will be the same for the UK ECU.
Dan
Trending Topics
#9
97-98 impreza ECU diagram is the one below i think
Mikey
See here for your ECU pin out.!! you want page 34 of the pdf.
http://www.mrtrally.com.au/performance/docs/WRX-V5.pdf
Dan
[Edited by dhorwich - 9/27/2003 9:30:17 AM]
Mikey
See here for your ECU pin out.!! you want page 34 of the pdf.
http://www.mrtrally.com.au/performance/docs/WRX-V5.pdf
Dan
[Edited by dhorwich - 9/27/2003 9:30:17 AM]
#12
It might be one of the 'pressure sensor' wires but dont quote me on it.. I think they are for the map sensor.. could be pin 4 on connector B43 but like i said dont quote me on it... someone else may be able to help..
Dan
Dan
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM