What thread and where can I get a tapper for these?
14 April 2003, 12:04 PM
#1
Need to find out what thread they are so I can tap the nuts to screw them in. Any ideas people, the codes on the side are NGK B8ES and B8EV (same thread though - the S and V related to the size of the contact in the middle)
Then I need to find out where I can get a tapper from, Part Co or any other enginering/car parts shop surely?
Also, how much do you reckon £15/20?
14 April 2003, 12:21 PM
#2
Scooby Regular
Join Date: Nov 2001
Location: Leeds - It was 562.4bhp@28psi on Optimax, How much closer to 600 with race fuel and a bigger turbo?
Posts: 15,239
Likes: 0
Received 1 Like
on
1 Post
take them to an engineering supplies shop..
or take them to a bolt company and ask for a nut with the correct thread..
Or ring hayward and scott and ask for a lambda boss..
David
or take them to a bolt company and ask for a nut with the correct thread..
Or ring hayward and scott and ask for a lambda boss..
David
14 April 2003, 08:22 PM
#4
Scooby Regular
iTrader: (1)
Join Date: Mar 2002
Location: Norn Iron
Posts: 2,786
Likes: 0
Received 0 Likes
on
0 Posts
Lambda boss uses a 2.0 pinto spark plug thread I think, not a normal smaller type.
Lambda is M18x1.5, normal plugs I think are M16 or M14, not sure of the thread pitch
[Edited by ustolemyname??stevieturbo - 4/14/2003 8:23:34 PM]
Lambda is M18x1.5, normal plugs I think are M16 or M14, not sure of the thread pitch
[Edited by ustolemyname??stevieturbo - 4/14/2003 8:23:34 PM]
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM