Q`s on engine temp sensor, thermometer sensor & Link
19 December 2002, 01:26 AM
#1
Scooby Regular
Thread Starter
Join Date: Mar 2000
Location: Tayside
Posts: 2,323
Likes: 0
Received 0 Likes
on
0 Posts
Hi peebs,
Need another lil bit of help here.
Where are the above sensors on an STi4 engine? (any pix)
Also if possible, what signals should they be sending when cold / hot ?
1 Final question, does the Link ecu use the signal from the engine temp sensor or the thermometer for the cold start monitoring reading?
Thanks in advance
Pete
Need another lil bit of help here.
Where are the above sensors on an STi4 engine? (any pix)
Also if possible, what signals should they be sending when cold / hot ?
1 Final question, does the Link ecu use the signal from the engine temp sensor or the thermometer for the cold start monitoring reading?
Thanks in advance
Pete
19 December 2002, 12:11 PM
#2
Scooby Regular
Join Date: Nov 2000
Location: 32 cylinders and many cats
Posts: 18,658
Likes: 0
Received 1 Like
on
1 Post
Link manual should answer all these? Only have the V5 manual - the one on MRT - they might have earlier ones on there?
Ravensblade has some extracts of wiring diags and sensor locations, not sure if it has for V4.
Ravensblade has some extracts of wiring diags and sensor locations, not sure if it has for V4.
Thread
Thread Starter
Forum
Replies
Last Post
aaron_ions
General Technical
17
03 November 2021 11:07 AM
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
ossett2k2
Engine Management and ECU Remapping
15
23 September 2015 09:11 AM
Bazil_SW
Engine Management and ECU Remapping
24
21 September 2015 11:55 PM