scoobybuzz

hi can anyone tell me where the best place to go through the bulk head is to run my 4 gauge power cable, its a my 94 wrx with air con
pleeeeez help

Moles Dad

Either under the brake master cylinder or under the fuel filter side....I used a 'wire coat hanger' type wire to push through the bulkhead grommet...tape the cable to the end of it and (with a helper) feed it through.

It wont be easy

I then seal the engine bay side with silicone sealant.

Keep the power and signal cables seperate (different sides of car) or you will get alternater whine !!!

Good luck.

scoobybuzz

thanks for that, but i wanted to use its own grommet and wasnt sure where to drill, what side is the fuel filter on , im having problems as the air con is in the way and i wanted to come down the passenger side of the car, anymore help would be appreciated, thanks

Moles Dad

Fuel filter is on the passenger side (RHD car), I dont know how easy it is to drill another hole...never done it.

The grommet I used had a metal pipe going through the b/head.

Cant tell you much more than that, good luck.

SlowBoy

iTrader: (1)

A little washing up liquid helps the cable slide through