Idle control valve torx
#1
Scooby Newbie
Thread Starter
Join Date: Apr 2017
Location: torbay
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
Idle control valve torx
So I have a lumpy idle and engine light, code says control valve issue so have removed the valve with the sensor but can I get the torx screws out of the sensor, I can see they are five points but can’t find anything that fits, nodes anyone know what type and size I should be using?
#3
Scooby Regular
Assuming it's a 2002 wrxsti
If you are trying to remove these screws below on the idle air control VALVE, then you are trying to remove the motor assembly that rotates the valve - not any sensor.
The pressure sensor sits next to the valve on the throttle body.
If you are trying to remove these screws below on the idle air control VALVE, then you are trying to remove the motor assembly that rotates the valve - not any sensor.
The pressure sensor sits next to the valve on the throttle body.
Last edited by Don Clark; 24 September 2023 at 05:44 PM.
The following users liked this post:
Thread
Thread Starter
Forum
Replies
Last Post