Newage floor tray cover onto blob ?
#1
Scooby Regular
Thread Starter
Newage floor tray cover onto blob ?
Has anybody retrofitted these from a widetrack to non-widetrack (as they didnt come with them?)
I know I will have to drill some holes , which initially I was terrified about, but im sanding the underside anyway and re undersealing it as im keeping it long term so zinc primer, then raptor + clear underseal. I was thinking of using RIVNUTS in the drilled holes covered in additional underseal to get in the nuk and crannys if you get me.
Does this look like its possible ? as I dont have any trays to check fitment first...
same trays as pic here
I know I will have to drill some holes , which initially I was terrified about, but im sanding the underside anyway and re undersealing it as im keeping it long term so zinc primer, then raptor + clear underseal. I was thinking of using RIVNUTS in the drilled holes covered in additional underseal to get in the nuk and crannys if you get me.
Does this look like its possible ? as I dont have any trays to check fitment first...
same trays as pic here
#3
Scooby Regular
Thread Starter
What steps did you take in rust prevention when drilling and fitting the rivnuts?
#4
Scooby Regular
Only picture I’ve got is on my build thread but it’s not very good - https://www.scoobynet.com/1061320-bu...l#post12081824
They fit all the shapes of the floor and sill properly but none of the existing holes were anywhere near. I sprayed some zinc primer in the holes before putting in the nuts.
They fit all the shapes of the floor and sill properly but none of the existing holes were anywhere near. I sprayed some zinc primer in the holes before putting in the nuts.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Car Parts For Sale
0
01 February 2019 11:38 AM
Mattybr5@MB Developments
Car Parts For Sale
0
13 July 2016 10:58 AM