MIKE25

hi i'm having issues with my sti, starts fine but soon after, the idle hunts or stays at 2k rpm. then the engine management light comes on, and starts to run on 3 cylinders,until you put your foot down and then pulls like nothing is wrong. any ideas on what this could be as i cant read the ecu as its looked with a ecutek map, which is extremely helpful
many thanks mike

peter zippy reid

iTrader: (25)

Buy a obd reader to get codes

MIKE25

had a friend try and read it with a snap on solus, it wouldn't read the fault codes.

peter zippy reid

iTrader: (25)

Ecutek doesnt lock out obd reading as all my scoobs had ecutek and i can read codes

peter zippy reid

iTrader: (25)

Could be maf

MIKE25

i will try another reader, and give the maf sensor a clean.

SHUNT88

Hi Mike. I had very similar symptoms on my 05 STi 2L. Hunting and high rpm idle. Not noticeable when driving until I dipped the clutch to change gear. Might be worth removing and cleaning the IACV idle air control valve. Sorted it for me.

Located right on top on the throttle body, 2 small screws to undo. Clean and wash it out with swabs and petrol. You will need a new rubber gasket (£5) to refit. Code I had was P0519. No issues now over 2 years on.

Cheers, Sam.

Tidgy

06 2.0? 05 is normaly a 2.5, unless its an import?

SHUNT88

Quite possibly a late registered wide track blob? I’ve seen quite a few on a 06 plate over the years actually, randomly most of them seem to be silver?!

MIKE25

it's hawkeye import 2.0, thanks for all the replies i will do cleaning and see what happens

Don Clark

Was wondering, - if JDM, ECU may not be capable of being read with OBD just SSM.