2006 2.0 sti rough running
hi i'm having issues with my sti, starts fine but soon after, the idle hunts or stays at 2k rpm. then the engine management light comes on, and starts to run on 3 cylinders,until you put your foot down and then pulls like nothing is wrong. any ideas on what this could be as i cant read the ecu as its looked with a ecutek map, which is extremely helpful
many thanks mike |
Buy a obd reader to get codes
|
Originally Posted by peter zippy reid
(Post 12011414)
Buy a obd reader to get codes
|
Originally Posted by MIKE25
(Post 12011415)
had a friend try and read it with a snap on solus, it wouldn't read the fault codes.
|
Could be maf
|
i will try another reader, and give the maf sensor a clean.
|
Hi Mike. I had very similar symptoms on my 05 STi 2L. Hunting and high rpm idle. Not noticeable when driving until I dipped the clutch to change gear. Might be worth removing and cleaning the IACV idle air control valve. Sorted it for me.
Located right on top on the throttle body, 2 small screws to undo. Clean and wash it out with swabs and petrol. You will need a new rubber gasket (£5) to refit. Code I had was P0519. No issues now over 2 years on. Cheers, Sam. |
06 2.0? 05 is normaly a 2.5, unless its an import?
|
Originally Posted by Tidgy
(Post 12011480)
06 2.0? 05 is normaly a 2.5, unless its an import?
|
it's hawkeye import 2.0, thanks for all the replies i will do cleaning and see what happens
|
Originally Posted by MIKE25
(Post 12011516)
it's hawkeye import 2.0, thanks for all the replies i will do cleaning and see what happens
|
All times are GMT +1. The time now is 03:28 AM. |
© 2024 MH Sub I, LLC dba Internet Brands